ieee standard 1149.1

I i

Transcription

- US Pronunciation
- US IPA

- US Pronunciation
- US IPA

Definitions of ieee standard 1149.1 words

abbreviation Technical meaning of IEEE STANDARD 1149.1 Joint Test Action Group 3
noun Definition of ieee standard 1149.1 in Technology (JTAG, or "IEEE Standard 1149.1") A standard specifying how to control and monitor the pins of compliant devices on a printed circuit board. Each device has four JTAG control lines. There is a common reset (TRST) and clock (TCLK). The data line daisy chains one device's test data out (TDO) pin to the test data in (TDI) pin on the next device. The protocol contains commands to read and set the values of the pins (and, optionally internal registers) of devices. This is called "boundary scanning". The protocol makes board testing easier as signals that are not visible at the board connector may be read and set. The protocol also allows the testing of equipment, connected to the JTAG port, to identify components on the board (by reading the device identification register) and to control and monitor the device's outputs. JTAG is not used during normal operation of a board. 1

See all 2 definitions of ieee standard 1149.1

Information block about the term

Parts of speech for Ieee standard 1149.1

noun

adjective

verb

adverb

pronoun

preposition

conjunction

determiner

exclamation

Full grammatical hierarchy of Ieee standard 1149.1

See also

All definitions of ieee standard 1149.1

Matching words

Was this page helpful?

Yes No

Thank you for your feedback! Tell your friends about this page

Tell us why?