7-letter words that end in 2
- 10base2 — (networking) (Or "cheapernet") The variant of Ethernet that uses thin coaxial cable (RG-58 or similar), as opposed to 10base5 cable. The "10" means 10 Mbps, "base" means "baseband" as opposed to radio frequency and "2" means a maximum single cable length of 200m.
- blaze 2 — An object-oriented successor to BLAZE.
- cdp1802 — RCA 1802
- eia-232 — (communications, standard) (Formerly "RS-232") The most common asynchronous serial line standard. EIA-232 is the EIA equivalent of ITU-T V.24, and V.28. EIA-232 specifies the gender and pin use of connectors, but not their physical type. RS-423 specifies the electrical signals. 25-way D-type connectors are common but often only three wires are connected - one ground (pin 7) and one for data in each direction. The other pins are primarily related to hardware handshaking between sender and receiver and to carrier detection on modems, inoperative circuits, busy conditions etc. The standard classifies equipment as either Data Communications Equipment (DCE) or Data Terminal Equipment (DTE). DTE receives data on pin 3 and transmits on pin 2 (TD). A DCE EIA-232 interface has a female connector. DCE receives data from DTE on pin 2 (TD) and sends that data out the analog line. Data received from the analog line is sent by the DCE on pin 3(RD). Originally DCE was a modem and DTE was a computer or terminal. The terminal or computer was connected (via EIA-232) to two modems, which were connected via a telephone line. The above arrangement allows a computer or terminal to be connected to a modem with a straight-through (2-2, 3-3) cable. It is common, however, to find equipment with the wrong sex connector or with pins two and three reversed, requiring the insertion of a cable or adaptor wired as a gender mender or null modem. Such an adaptor is also required when connecting a computer directly to a terminal or to another computer without the use of modems.
- eia-422 — (communications, standard) (Formerly "RS-422") An EIA serial line standard which specifies 4-wire, full-duplex, differential line, multi-drop communications. The mechanical connections for this interface are specified by EIA-449. The maximum cable length is 1200m. Maximum data rates are 10Mbps at 1.2m or 100Kbps at 1200m. EIA-422 cannot implement a truly multi-point communications network (such as with EIA-485), although only one driver can be connected to up to ten receivers. The best use of EIA-422 is probably in EIA-232 extension cords.
- layer 2 — data link layer
- occam 2 — (language) An extension of occam produced in 1987. Occam 2 adds floating-point, functions and a type system.
- rfc 792 — (networking, standard) The RFC defining Internet Control Message Protocol.
- rfc 822 — (messaging, standard) The RFC defining the Internet standard format for electronic mail message headers. Also STD 11, evolved from RFC 733.
- snobol2 — A SNOBOL variant which existed only briefly. It featured built-in functions, but not programmer-defined ones.
On this page, we collect all 7-letter words ending in letter 2. It’s easy to find right word with a certain length. It is the easiest way to find 7-letter word that ends in 2 to use in Scrabble or Crossword puzzles.